LUMINAIRE LEADS
Lighting Controls manufacture a range of luminaire leads that provide a pluggable connection between an LCM and luminaires. These leads can be manufactured with a variety of plugs, such as Metway, Enstow, Wago, and Wieland to ensure compatibility with any luminaire within a building. Lengths can also vary.
6 & 9 PORT MDB
The Master Distribution Box is supplied pre-wired with a home run cable containing up to 9 LSOH circuits. The home run cable is housed within a flexible galvanised steel conduit up to 40mm diameter, BASEC approved 6491B LSOH singles up to 6.0mm². The system can also incorporate selected bus cable for a fully integrated lighting and controls solution.
LIGHTING INTERLINK CABLES
The Armoured Lighting Interlink Cable provides a power and bus between point (A) and point (B) within the modular cabling system, typically between a MDB and Flying Tee on a lighting control module. Leads are pre-wired, male to female, in a length appropriate to the installation.
SWITCHED FUSED SPUR
The Lighting Controls Switch Fuse Spur provides a 13A protected supply to a fan coil unit via either a flexible conduit containing suitably sized LSF cables, or a multi-core LSOH flexible cable. An integral bus can be provided within the conduit if required, (when it becomes a 5-pole system). Other fuse ratings are also available.
FLYING TEE - LIGHTING
The Armoured Lighting Tee provides a power and data in and out facility to lighting control modules, light fittings and other series-connected equipment.The flying tee is fitted to our LCM, or provided to a third party lighting manufacturer for assembling into their system.
STARTER & END CABLES
This range of armoured starter and end cables is designed to provide the start and final power and data supply to a circuit not connected to a modular distribution box. Leads are supplied pre-wired female to free end (for the starter cable) or male to free end (for the end cable), in a variety of lengths.
POWER INTERLINK
CABLES
The Lighting Controls Armoured Power Interlink Cable provides a power and bus between point A and point B within the modular cable system, typically between a MDB and Fan Coil Unit.
FLYING TEE - POWER
The 3-pole Armoured Power Tee is designed to provide a power in and out facility enabling low power circuits to be connected in series. The Tee would be fitted to the FCU or independently fixed in the ceiling void.
UNDERFLOOR POWER DISTRIBUTION
The 6 Port PDU is supplied pre-wired with a home run cable or with a male and female 4 pole 32 A connector. The male connection on the PDU is the incoming connection from the power supply with a female starter 3 or 4 core 4.0mm² BASEC approved BS7211 LSOH 6491B cable